As he described it, the Terminator is coming whether we like it or not so we need a Summer Glau.

Docker doesn’t require podman at all

Podman isn’t an addon for docker. Podman is the open source alternative containerizer to docker. When I first encountered Docker’s AI Bonzai buddy called Gordon, Lemmy responded with, “Lol, everyone knows to not run Docker.”

:

No, I am aguing that if you were capable of setting up Cisco BGPs in the mid-90s, when documentation was ass,

Documentation was far more thorough and accurate than today. First was everything was simpler. No VMs, No Containers. No https certificates unless they were e-commerce. The second reason is that documentation wasn’t an afterthought because the project is done by volunteers. I got a 100+ page binder from Netscape just to cover how to configure their build kit. (The software to make a customized installation CD.) Today many projects documentation consists only of, “Check out the Discord.”

The last important factor was the rate of change was slower so the documentation you got in 1996 was still completely accurate in 1999.

Edit: Re docker engine.

The guides say install docker engine and point you to the docker website. Once on the docker website, the docker documentation tells you to install the docker gui to get the engine installed and walks you through the procedure of installing docker gui.

Jellyfin but you not being able to follow a dead simple guide.

The fact that others had the same problem without solution means it isn’t follow a dead simple guide. There are multiple guides. Just setting up docker means you have to already know to not use it and run podman. Because if you follow the online guides on docker’s own website, you end up with a docker gui and their AI assistant installed.

And to think you were running a whole ass ISP…

You are arguing that setting up an Internet server is as simple as it was 30 years ago. You are arguing for the sake of arguing.

Not at Cisco. With a Cisco. I ran a mid sized ISP in the 90’s until I was bought out by a cable company and retired. Although several of my employees went on to work at Cisco. I also had a few friends who were executives at Cisco because we all started at a company working for Vint Cerf and Bob Khan (they were the angel investors) back before most knew of the Internet.

First it’s a VM because I’m not going mess around with stuff on bare metal. Create docker is a can of worms because you have to pick a reverse proxy software like nginx, traefik, caddy. Which means you need to understand all three to know which to pick. Then there’s setting up the certificate with the dns provider. So I got nginx working with a certificate but gave up after the VM running Jellyfin couldn’t see it. Googling showed someone on Reddit with the same problem but no answer other than others saying “works for me”

The start of this thread is “number one reason people don’t move to Jellyfin is ease of remote access.”

30 years ago I was compiling slackware and configuring dns servers, and setting up BGP on Ciscos. But a few hours of attempting to setup Jellyfin was a failure. It was far more complex than setting up dns/bind.

That’s fine for your personal remote access but that doesn’t help your 80 year old mother in law watch videos of the grandchildren on a Roku.

I did that and it works well. The only problem is that when the battery goes to 0 on a long outage, the UPS can’t recharge it. I had to pull the battery, charge it with a lifepo4 charger, then reinstall.

Short outages are fine.

If you are using a buck converter you might as well use a ups. They’re both going to be ~ 95%.

The pci slots were called isa.

“Unresizeable block device at end of disk”

Classically the swap partition was located at the physical middle of the drive so that on average, no matter where the heads where, the swap partition wasn’t far away

Historically swap needed to be a minimum of installed ram.

I don’t understand the purpose of the exposed daisy chained cables. If it is not meant to be frequently unplugged, then why not wire an internal bus of 14 awg with Wago?

Music cli. Sex seems to be joke option.

I haven’t used BlueMorpho anywhere but here. I picked it because of Venture Brothers but then noticed it has a political connotation.

It was as easy as pouring a lot on a paper towel, rub on, and let dry for a day. I tried isopropyl and the baking soda scrub but acetone worked best. I think it works best because isopropyl only cleans off the outer sticky layer and baking soda scrubs it off as an abrasive (works but very slow).

I fixed a logic mouse, a bodum coffee grinder, and the handle of a fancy umbrella.

Even at current prices it’s $3k tops.

AI has poisoned me so much that you might have spent hours on this creative writing and I only think it was prompted.

I have fixed many “soft touch” plastics that have degraded to sticky with acetone. I believe it dissolves the soft touch with the underlying abs leaving behind a hard plastic after it evaporates.

I thought hbm would have already become standard by now. It’s been out for over 10 years. Years ago I thought it would be like 16 GB of HBM on the CPU package as layer 4 cache with ram slots as optional if you needed more.

I quoted Plex documentation where it explains in detail that you need port 32400 OPEN for remote access. https://support.plex.tv/articles/200289506-remote-access/

I linked the CVE but here is the plain language version because you didn’t read what I linked:

https://www.howtogeek.com/over-300k-plex-servers-are-still-vulnerable-to-attackers-despite-emails/

"The flaw has been assigned a CVSS score of 10.0, the highest possible level of severity. This score indicates that the vulnerability can be exploited remotely over the internet, is easy to execute, and requires no authentication or interaction from the server’s owner. A successful attack could result in a total loss of confidentiality, integrity, and availability. An attacker could access, modify, or delete a user’s private media files, or even disable the entire Plex server. "

What the fuck is wrong with you?